Mega System Tech iCV-03 Bedienungsanleitung PDF herunterladen (Seite 23)

OCTE SAFEdoc

FAB

Band Saw (cont.)

14. Always operate the saw from the front never from the side.

15. Do not leave the band saw until the blade has stopped.

16. Ensure that the blade is running at full speed before starting a cut.

17. Cut on the waste side of your line, leaving the pattern line on the work.

18. Keep your hands beside or behind the blade. Never in front. Use a push stick on

small pieces.

19. Make sure all guards are in place and properly adjusted. Ensure all band wheels

are enclosed.

20. Ensure the blade is tracking correctly and runs freely in the upper and lower guide

rollers. Ensure the blade is under proper tension. See your instructor for guidance.

21. Use band saw blades that are sharp, properly set and otherwise suitable for the

job (e.g., the right tooth pitch; tooth form; blade width).

22. Hold stock firmly and flat on the table to prevent the stock from turning and

drawing your fingers against the blade.

23. Use a push stick when you remove cut pieces from between the fence and saw

blade or when your hands are close to the blade. Keep your hands on either side

of the blade - not in line with the cutting line and the blade.

AT ALL TIMES – IF IN DOUBT, SEE YOUR INSTRUCTOR

FAB SAFEdoc Page 20

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 119 120

Keine Kommentare

Mega System Tech iCV-03 Bedienungsanleitung Seite 23